Downloads at Diagnostic Associates Ltd - bespoke hardware, software and support solutions

Downloads

DA J2534 Device Setup

The DA J2534 Device Setup application is required for the DA-VINA 2534 and DA-Dongle J2534 Pass-Thru device drivers. This application installs the required PC interface files to allow the support of the SAE J2534 Pass-Thru standard.

It is important to use the correct version of DA device software in conjunction with the PC device drivers. For version 3.4 the associated DA-VINA 2534 device software version is 53 and the DA-Dongle J2534 device software version is 51. This can be updated using the DA Software Update Tool available from this website.

J2534 Pass-Thru device users should follow the procedure below when first using their DA J2534 devices to work with OEM PC applications:

Please Note: A reboot may be required after the DA J2534 Device Setup is installed to complete driver installation.

Once you have installed the J2534 drivers onto your target PC you should connect your DA J2534 communications device to the vehicle before connecting to the target PC (via the USB cable). If you have done this correctly you will see the STS LED on the device flashing RED & GREEN and the PWR LED will be illuminated RED. When you are in this correct state your device is now ready to be used. This sequence must be followed for each subsequent connection to a vehicle (i.e. connect device to vehicle then connect device to target PC). If only the PWR LED is illuminated following this procedure, then you have connected the device to the PC before the vehicle.

Please Note: Some OEM PC applications (such as JLR IDS/SDD) may require you to perform a once only configuration/setup to use your new J2534 device. This can only be done once you have followed the connection procedure above.

Download

Version:	3.4
Release Date:	07/02/2012
File Size:	50.3Mb
System Requirements:	Windows XP SP2 & SP3
	Windows Vista SP1
	Windows 7

DA Software Update Tool Setup

The DA Software Update Tool is a PC based application that is installed to allow you to check for software updates to your DA Dongle and DA-VINA 2534 devices.

The PC that this application is installed on needs to be connected to the internet to allow software updates to be downloaded automatically to your DA device.

Please Note : After installation of the DA Software Update Tool you need to connect your DA device to your PC via the USB cable BEFORE you run the DA Software Update Tool for the first time. This is necessary to complete the device driver installation.

Download